“UbuntuHelp:Ntop”的版本间的差异
来自Ubuntu中文
小 |
小 |
||
(未显示同一用户的2个中间版本) | |||
第39行: | 第39行: | ||
restart the service with | restart the service with | ||
<pre><nowiki> | <pre><nowiki> | ||
− | + | /etc/init.d/ntop restart | |
</nowiki></pre> | </nowiki></pre> | ||
== Access == | == Access == | ||
第46行: | 第46行: | ||
== Links == | == Links == | ||
[http://www.ntop.org/] | [http://www.ntop.org/] | ||
− | [[category: | + | ---- |
+ | [[category:CategoryNetworking]] | ||
[[category:UbuntuHelp]] | [[category:UbuntuHelp]] |
2009年11月17日 (二) 20:15的最新版本
Ntop shows the current network usage. It displays a list of hosts that are currently using the network and reports information concerning the IP (Internet Protocol) and Fibre Channel (FC) traffic generated by each host. The traffic is sorted according to host and protocol. Protocols (user configurable) include:
- TCP/UDP/ICMP
- (R)ARP
- IPX
- DLC
- Decnet
- AppleTalk
- Netbios
- TCP/UDP
o FTP o HTTP o DNS o Telnet o SMTP/POP/IMAP o SNMP o NFS o X11
- Fibre Channel
o Control Traffic - SW2, GS3, ELS o SCSI (In human-readable, this means you can very comprehensively monitor your network traffic, connections & bandwidth via a web output)
Installation
Packages needed for installation are:
ntop
You can just type the following to install it (make sure you enable the Universe repositories): [1]
sudo apt-get install ntop -y
Configuration
When first installing & configuring the ntop application you need to set an admin password.
sudo ntop --set-admin-password
restart the service with
/etc/init.d/ntop restart
Access
To access your network statistics via the web visit the web address: [2]