特殊:Badtitle/NS100:BridgingNetworkInterfaces

来自Ubuntu中文
Wikibot留言 | 贡献2007年11月22日 (四) 12:09的版本
跳到导航跳到搜索
可打印版本不再受到支持且可能有渲染错误。请更新您的浏览器书签并改用浏览器默认打印功能。

{{#ifexist: :BridgingNetworkInterfaces/zh | | {{#ifexist: BridgingNetworkInterfaces/zh | | {{#ifeq: {{#titleparts:BridgingNetworkInterfaces|1|-1|}} | zh | | }} }} }} {{#ifeq: {{#titleparts:BridgingNetworkInterfaces|1|-1|}} | zh | | }}

I struggled to find the right information, so I think this might be useful! If you want to write to me directly, my e-mail is on my wiki page at Ubuntu:HervéFache.

Also, consider this article: [1] on the same subject.

Installing bridge utilities

You will need the bridge utilities for that, which all you need to do is install the bridge-utils package.

apt-get install bridge-utils 

Setting up bridge utilities

With no further ado, this is my /etc/network/interfaces file:

# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

# The loopback network interface
auto lo
iface lo inet loopback
address 127.0.0.1
netmask 255.0.0.0


# This is a list of hotpluggable network interfaces.
# They will be activated automatically by the hotplug subsystem.
auto eth0
auto ath0
auto br0


# The internet network interface
iface eth0 inet dhcp


# The wireless side of the bridge
iface ath0 inet manual
wireless-essid MY_ESSID
wireless-key **********
wireless-mode master

# The local network bridge
iface br0 inet static
bridge_ports ath0 eth1
address 192.168.0.2
netmask 255.255.255.0

The explanation is as simple as this file: the system is going to start eth0 (the internet side network interface), ath0 (the wireless network interface) and br0 (the bridge). ath0 being 'manual' and not 'static' or 'dhcp', no IP will be assigned to it, but I need the 'auto' to set the wireless parameters. eth1 is set up automatically as part of the bridge setup.

Note: the bridge takes time to come up. Be patient!

Before you start complaining, you should know that in fact, this does not work for me. For some reason, the atheros wireless interface goes back down in the process. I tried very hard to find a way to bring it back up, and the only one I could rely on was to add this in /etc/rc.local, just before the line containing 'exit 0':

ifconfig ath0 up

This is an ugly hack, but at least it does bring ath0 up...

Note for Edgy users: the madwifi driver does not support setting the mode this way, and even using the required tool did not provide me a working access point.